Canon iR2020 Trouble Codes List page 1 from 4

  • Code: E000-0000
  • Description: Fixing temperature abnormal rise
    The temperature detected by the main or sub thermistor does not rise to the specified value during startup control.
  • Remedy: - Check the fixing film connector. - Replace the fixing film unit. - Replace the DC controller PCB.
  • Code: E001-0000
  • Description: Fixing unit temperature rise detection (by main thermistor)
    The main thermistor detected an abnormally high temperature (240 deg C) during temperature control.
  • Remedy: - Check the connector of the fixing film unit. - Replace the fixing film unit. - Replace the DC controller PCB.
  • Code: E001-0001
  • Description: Fixing unit temperature rise detection (by sub thermistor)
    The sub thermistor detected an abnormally high temperature (295 deg C) during temperature control.
  • Remedy: - Check the connector of the fixing film unit. - Replace the fixing film unit. - Replace the DC controller PCB.
  • Code: E002-0000
  • Description: Low temperature during temperature control.
    The target temperature is not reached during temperature control.
  • Remedy: - Check the connector of the fixing film unit. - Replace the fixing film unit. - Replace the DC controller PCB.
  • Code: E003-0000
  • Description: Abnormally low temperature (detected by main thermistor)
    After the temperature detected by the main thermistor has reached the specified value, it does not reach the specified value during initial rotation.
  • Remedy: - Check the connector of the fixing film unit. - Replace the fixing film unit. - Replace the DC controller PCB.
  • Code: E003-0001
  • Description: Abnormally low temperature (detected by sub thermistor)
    After the temperature detected by the sub thermistor has reached the specified value, it does not reach the specified value during initial rotation.
  • Remedy: - Check the connector of the fixing film unit. - Replace the fixing film unit. - Replace the DC controller PCB.
  • Code: E007-0000
  • Description: Fixing film sensor failure
    The fixing film sensor is faulty.
  • Remedy: - Check the connector of the fixing film sensor. - Replace the fixing film sensor. - Replace the DC controller PCB.
  • Code: E010-0000
  • Description: Main motor failure
    The main motor is faulty.
  • Remedy: - Check the connector of the main motor. - Replace the main motor. - Replace the DC controller PCB.
  • Code: E019-0000
  • Description: Waste toner full detection
    The waste toner full state was detected.
  • Remedy: Replace the drum unit.
  • Code: E019-0001
  • Description: Waster toner full detection sensor failure
    The waste toner full state was detected continuously for five or more seconds while the main motor was turning.
  • Remedy: - Check the connector of the waster toner full sensor. - Replace the waste toner full sensor. - Replace the DC controller PCB.
  • Code: E052-0000
  • Description: Duplex unit connection error
    Disconnection of the duplex unit was detected after power-on, detection of normal connection to the duplex unit, and start of communication.
  • Remedy: - Check the connectors of the duplex unit and DC controller PCB. - Replace the duplex controller PCB. - Replace the DC controller PCB.
  • Code: E100-0000
  • Description: BD detection PCB failure
    The BD detection PCB is faulty.
  • Remedy: - Check the connector of the BD detection PCB. - Replace the laser scanner unit. - Replace the DC controller PCB.